- unused variable ‘walk’ [-Wunused-variable]
- implicit declaration of built-in function ‘free’
[-Wimplicit-function-declaration]
- initialization discards ‘const’ qualifier from pointer target type
[-Wdiscarded-qualifiers]
- variable 'ram_used' is used uninitialized whenever 'if' condition is
false [-Wsometimes-uninitialized]. This is actually easily reproducible
by specifying `memory_used_method = "XXX"`.
- comparison of integers of different signs: 'int' and 'unsigned long'
[-Wsign-compare] (for `exponent`)
Previously the format placeholders were auto-converted to the maximum possible
unit, e.g. /proc/meminfo reports MemTotal of 16307104kB which will get
converted to 15.6GiB. It is now possible to specifiy the target unit, e.g. Mi,
which will be used for the conversion - in the example it would lead to
15924.9MiB.
The resulting number can now be further formatted via the decimal option. It
allows to specify the number of decimals to use, e.g. 15.6GiB vs. 15GiB or
15924.9MiB vs. 15925MiB.
Added a function to print file contents to status bar without newlines.
Added tests for print file contents function
Added manpage entry for file contents
This commit implements the %devicename specifier for the volume module
for both PulseAudio and ALSA. This way, i3status will be able to display
the specific device that corresponds to the volume indicator.
Note that this is not implemented for the OSS API but is left in a state
where someone can pick it up for the future.
This change addresses the issue #199 asking for multiple CPU support. It
takes an arbitrary CPU number and outputs its usage using the same
arithmetics as for CPU aggregation. It currently doesn't support
FreeBSD.
Using title number all, this enables aggregates. Note that FreeBSD and
OpenBSD previously only reported aggregates, so this is bringing Linux
and NetBSD that functionality.
Changes the default battery reporting to the aggregate since most
users probably don't care about individual batteries. For single-battery
systems there should be no change.
Fixes one obvious memory leak in NetBSD.
Currently i3status differentiates wireless and wired devices based
on the existence of wireless directory inside the device's sysfs
directory. This approach seems to cause 3g modems to be incorrectly
identified as the first ethernet device.
This commit solves this problem by using DEVTYPE variable from
uevent file.
Signed-off-by: Cihangir Akturk <cakturk@gmail.com>
CPU usage had previously not supported the color option. Add support
for a "degraded" state above which the degraded color is used, and a
higher "bad" state above which the "bad" color is used. One possible
use for these might be indicating whether one or all cores are
saturated.
Unlike the color settings for other, these are set high enough to be
disabled by default. This is done because i3status determines CPU
usage over only the last display interval, which means that, a user
with a low refresh rate might see frequent, potentially-annoying color
changes.
Since we have deterministic device names in Linux, these strings are a
much better default in the i3status config than "eth0" and "wlan0" (what
we used before).
Replaced hard coded status strings (CHR, BAT, FULL) in
print_battery_info.c with user defined strings. The new strings are
'status_chr', 'status_bat' and 'status_full' and can be set in i3status.conf.
e.g.
status_chr = "⚡ CHR"
If any of the new status strings is omitted the standard strings (CHR,
BAT, FULL) are used.
